Blinking lights on an air conditioner (AC) could cause concern. Still, they usually point to common problems that may be fixed fast without professional assistance. Knowing the reasons behind these blinking lights and taking quick care of them will help your air conditioner run as it should. The article offers thorough responses to enable you to handle these problems successfully.
But after all the fixes, if the blinking problem still exists, don’t hesitate to contact https://www.airconservicing.org/aircon-is-blinking/.
Investigate Problems With Power Supply:
A power supply problem is among the most often occurring causes of blinking AC lights. The AC unit might not be getting constant power, which would cause running problems. Start by looking at the circuit breaker; turn it off for thirty seconds then back on. If the issue continues, check the power cord to be sure it is not damaged and correctly attached. Another way to find whether the problem is restricted to the AC is testing other appliances running from the same power socket. Often resolving power supply problems results in the blinking lights stopping and normal operation being restored.
Change Or Clean Your Air Filters:
Another often occurring reason of blinking lights is dirty air filters. For correct airflow, air conditioners depend on clean filters. The system suffers to run effectively when filters get blocked with dust and trash, which sets off warning signals like flashing lights. Remove the filters and look for dirt accumulation in order to fix this. Before reinstallation, washable filters should be washed with water and allow to dry totally. Changing the filters is the best course of action if they are past their cleaning value. Every one to three months, air filters should be routinely maintained by a professional like airconservicing.org/ to avoid airflow problems and maintain the AC functioning without faults.
Review Remote Control Settings:
Sometimes misadjusted remote control settings cause flickering lights. Should the timer function be unintentionally triggered, for example, the AC may flash its lights as a warning. Check the remote again for any accidental changes. Make sure the temperature is set for the present weather conditions exactly. Additionally, communication between the device and the AC unit may be disrupted by weak batteries in the remote. Usually, changing the batteries with new ones fixes these little problems. Precise remote settings guarantee flawless performance free from needless blinking signals.
Check Correct Drainage:
A blocked drainage system might generate blinking lights; air conditioners remove moisture from the air. Usually found at the rear or side of the unit, find the drainage pipe and look for obstructions. Clear any obstructions in case water is gathering with a flexible brush or a wet/dry vacuum. Empty any standing water and look over the drain pan. Frequent maintenance of the drainage system helps to avoid water-related problems that could disturb operations and produce blinking warning signals.
Examine Condenser And Cooling Coils:
Blinking lights can also be set off by frozen or filthy cooling coils. Restricted airflow causes the coils to freeze, therefore prohibiting effective AC operation. Should the coils freeze, turn off the device and let them defrost fully. To get collected dirt and waste out of the coils after thawing, gently brush them or use a commercial coil cleaning. Also make sure furniture or curtains do not block air vents. Functional and clean coils increase efficiency and assist to stop blinking lights connected to cooling problems.
Perform a System Reset:
Often the blinking light problem can be fixed with a basic system reset. Using the remote control or power button, turn off the AC unit. Unplug the machine from the power source, then wait five to ten minutes before connecting it back in. Revers the AC and see whether the blinking stops. Usually without technical assistance, this technique fixes temporary system faults and usually brings normal operation.
jawad ali